Web service for device (WS4D) and using make, cmake with Integrated Development Environments (IDEs) on Linux

WS4D-gSOAP is a framework to deploy web services on multiple environments (computers, embedded devices, phones…) without having to rewrite code. More introduction information can be found in this post. The downside for WS4D is that the build system is based on cmake, and it’s a bit complicated to use. I have since managed to successfully build the stack from source (there’s no binary distribution). But I ran into numerous problems during my time getting familiar with the stack. Namely following the tutorial.

Even for such a simple task of copying and pasting code from the tutorial (The Air Conditioner tutorial), I did not succeed. The client and device doesn’t seem to be able to communicate with each other. Even though the tutorial have been kind enough to include logging code (send, received and memory allocations), I’m still unable to figure out where the problem lies. And that’s when I think I’m forced to perform debugging on the project. That leads to a big problem: what am I supposed to use to debug this?

So I tried to install Code Blocks, but it doesn’t support cmake projects, it couldn’t import the CMakeList.txt. Then reading through several articles revealed Eclipse to be a pretty good gdb front-end, I installed it, and have successfully imported the project, but I was hit with several problems:

• I couldn’t build the project, Eclipse’s project structure was make-based, not cmake-based, trying to ‘make all’ or ‘make clean’ with Eclipse obviously would generate errors
• Editing  the code is an eyesore because Eclipse doesn’t seem to be able to recognize include and libraries directories even after I added them manually in project properties.